HealthCast

Remote Deployment Steps

Pre-Installation Check and Steps

  1. Ensure that the correct server software has been properly installed in your environment.

  2. Verify that the target system meets the QwickACCESS system requirements

    1. QwickACCESS requires the 32-bit edition of Java even when installing on a 64-bit computer.

  3. Plug a supported proximity card reader into an available USB port on the client computer.

  4. On thin-client devices, enable changes before the installation and then commit those changes appropriately before rebooting.

Begin with an Interactive Install to Create QwickACCESS Settings

  1. Install QwickACCESS using the Interactive Installation instructions on one local workstation in your environment.

  2. Use the Client Configuration Tool to configure QwickACCESS for your work environment.

  3. Copy the qa.ini file created by the Client Configuration Tool. This file is located in the following folder:

    • %ALLUSERSPROFILE%\HealthCast\QwickACCESS\qa.ini

Remote Deployment Steps

  1. Locate the QwickACCESS-Client-Setup.exe file and install it, along with the qa.ini file (copied in step 3 above), using your desired remote deployment software. Note: qa.ini file must be deployed to the following folder:

    1. %ALLUSERSPROFILE%\HealthCast\QwickACCESS\qa.ini

  2. Further configuration changes my be made by running the Client Configuration Tool, navigating to the location of qa.ini in the directory, and pushing-out the newest qa.ini file to your client workstations.